![]() Enter the appropriate value according to the type of local identifier if needed. Choose the same method of local identifier as the tunnel from the Local Identifier drop-down list. Only check the ones defined under the Phase 1 tab. Uncheck all the unused Encryption and Authentication methods. Choose the same DH group from the Perfect Forwarding Secrecy (PFS) Group drop-down list which you entered for the the configuration of the tunnel. Choose the same time unit of the lifetime from the Lifetime drop-down list which you entered for the configuration of the tunnel and Phase 1. Enter the same lifetime in the Lifetime field which you entered for the the configuration of the tunnel and also Phase 1. Phase 2 is the security association to determine the security of the data packet during the data packets pass through the two end points. Aggressive - Represents the exchange mode for Full Qualified Domain Name (FQDN) gateway.Main - Represents exchange mode for all type of gateway except Full Qualified Domain Name (FQDN).Choose the appropriate exchange mode from the Exchange Mode drop-down list. The type of authentication determines the method to authenticate ESP packets. Choose the authentication method which you entered for the configuration of the tunnel from the Authentication drop-down list. The Encryption method determines the length of the key used to encrypt/decrypt Encapsulating Security Payload (ESP) packets. Choose the encryption type from the Encryption drop-down list which you entered for the configuration of the tunnel. The Diffie-Hellman (DH) group is used for key exchange. ![]() Choose the same DH Group which you entered for the configuration of the tunnel from the DH Group drop-down list. Choose the appropriate time unit for the Lifetime from the Lifetime drop-down list. ![]() The default value for Phase 1 is 28800 seconds. The key lifetime can range from 1081 to 86400 seconds. If time expires, a new key is renegotiated automatically. Enter the lifetime you entered during the configuration of the tunnel in the Lifetime field. Phase 1 is the simplex, logical security association (SA) between the two ends of the tunnel to support secure authenticated communication. Enter the remote network address in the Network Address field. Enter the subnet mask in the Network Mask (CIDR) field. In the Remote Side area, choose Network from the Endpoint Mode drop-down list. Note: You do not need to configure Local Side as this configuration is for remote client. Enter the IP address of the remote router in the Remote IPSec Device field. Enter a name for the new connection under connections. Click the + icon to add a new connection. From the menu bar, choose Connections > Edit Connections. ![]() To know more how to configure VPN Client to Gateway refer to Set Up a Remote Access Tunnel (Client to Gateway) for VPN Clients on RV016, RV042, RV042G and RV082 VPN Routers. Note: The VPN Client to Gateway configuration of the device needs to be done first.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |